全体表示

[ リスト ]

イメージ 1

MA:MZ:RX8:LA-SE3P:13B-MSP:095:ABS:DTC:C2778:G-scan2:


C2778
― An error is detected for the voltage to the combined sensor.

DTC C1279, C1280, C1281, C1282, C2778 [DYNAMIC STABILITY CONTROL (DSC)]

https://euroesi.mazda.co.jp/esicont/eu_eng/mazda3/20060311105619/html/id0402b2804100.html

閉じる コメント(7)

顔アイコン

ABS HU/CM INSPECTION

https://euroesi.mazda.co.jp/esicont/eu_eng/mazda3/20060311105619/html/id041300801000.html

2017/2/23(木) 午前 9:13 [ ogw*og*3 ]

顔アイコン

DSC HU/CM REMOVAL/INSTALLATION

id041500801000

Caution
• When replacing the DSC HU/CM, the configuration procedure must be done before removing the DSC HU/CM. If the configuration is not completed before removing the DSC HU/CM, DSC will not work properly after installation of the DSC HU/CM.

https://euroesi.mazda.co.jp/esicont/eu_eng/mazda3/20060311105619/html/id041500801000.html

2017/2/23(木) 午前 9:15 [ ogw*og*3 ]

顔アイコン

• The DSC may not function normally immediately after the DSC HU/CM is replaced. After installation, always perform the initialization procedures for the combined sensor, brake fluid pressure sensor.

2017/2/23(木) 午前 9:16 [ ogw*og*3 ]

顔アイコン

• Always use the adapter that comes with a new DSC HU or DSC CM when separating the DSC HU or DSC CM. Otherwise, the pump motor may come off the DSC HU and be damaged. Therefore, do not separate the DSC HU and DSC CM unless replacing them. When replacing them with new ones, always perform procedures according to the instructions included with the new parts.

2017/2/23(木) 午前 9:16 [ ogw*og*3 ]

顔アイコン

• The internal parts of the DSC HU/CM could be damaged if dropped. Be careful not to drop the DSC HU/CM. Replace the DSC HU/CM if it is subjected to an impact.

2017/2/23(木) 午前 9:17 [ ogw*og*3 ]

顔アイコン

POSSIBLE CAUSE
• Open or short circuit in the wiring harness between DSC HU/CM terminal AB and combined sensor terminal D
• Open or short circuit in the wiring harness between DSC HU/CM terminal AH and combined sensor terminal E
• Open circuit in the wiring harness between DSC HU/CM terminal T and combined sensor terminal A (CAN2 line)

2017/2/23(木) 午前 9:20 [ ogw*og*3 ]

顔アイコン

• Open circuit in the wiring harness between DSC HU/CM terminal H and combined sensor terminal B (CAN2 line)
• Combined sensor malfunction
• Poor connection at connectors (female terminal)

2017/2/23(木) 午前 9:20 [ ogw*og*3 ]


.


プライバシー -  利用規約 -  メディアステートメント -  ガイドライン -  順守事項 -  ご意見・ご要望 -  ヘルプ・お問い合わせ

Copyright (C) 2019 Yahoo Japan Corporation. All Rights Reserved.

みんなの更新記事